YoWindow Forum

Hi Pavel,

When I switch between two locations using the airport landscape, any airplane on the runway or landing or taking off stops where it is and stays there. You can make them go away by minimizing then maximizing YoWindow.

I switched between locations several times as an airplane came on screen and then took these screenshots. All of those airplanes are stopped even the ones in the air.

A refresh error maybe?

Don

Hi Pasha,

I tried the airport landscape. As Don has shown, a real traffic jam occurs.

I tried my own airport locations of Cleveland, Columbus, and Cincinnati Ohio. Earlier in the day, I was able to create a traffic jam between Columbus and Cincinnati as they were about the same temperature and the same season landscape. The temperature dropped in Columbus causing winter to display and Cincinnati was still naked. I could no longer cause a traffic jam as 2 different landscapes.

So I tried Cleveland and Columbus as they were now the same season landscape. I was creating a traffic jam again.

I hope this information helps you out.

Marty