RC 436

[FvE]

Hi Pasha,

After adding the South Pole as a location, I found the inspectorpane adjusted accordingly:

Inspectorpane 1.jpg (106.66 KiB) Viewed 4401 times

Switching back to another location however, the Inspectorpane did not (re-)adjust:

Inspectorpane 2.jpg (69.73 KiB) Viewed 4401 times

I haven't checked this on previous RC's.

Fred

[ikarus1969]

Hi Pasha,

After adding the South Pole as a location, I found the inspectorpane adjusted accordingly:

Inspectorpane 1.jpg

Switching back to another location however, the Inspectorpane did not (re-)adjust:

Inspectorpane 2.jpg

I haven't checked this on previous RC's.

Fred

Do you mean after switching back to St. Petersburg the inspector-pane doesn't get narrower according to the location name?
It always is as wide as the longest location-name needs to fit in.

If you change the location-name of the Southpole for testing purposes to, let's say, "S-Pole" then the width of the inspector-pane gets more narrow.

[FvE]

Do you mean after switching back to St. Petersburg the inspector-pane doesn't get narrower according to the location name?
It always is as wide as the longest location-name needs to fit in.

If you change the location-name of the Southpole for testing purposes to, let's say, "S-Pole" then the width of the inspector-pane gets more narrow.

You're Right Reinhart,

After renaming it (to South Pole) everything looked familiair again.
Since it displayed 'Amundsen-Scott South Pole St', with half of the 't' (see my original screenshot), I thought something went wrong with the rescaling in general.
Thanks for helping me out.

Fred

[ikarus1969]

Thanks for helping me out.

You're welcome!